at-international tl32300 User Manual

4

Battery installation and charging

Once you have installed the battery, the screen indicates 
the battery status (see the table below). If necessary, place 
the handset in the telephone base or charger to charge 
the battery. For best performance, keep the handset in the 
telephone base or charger when not in use. The battery is 
fully charged after 6 hours of continuous charging.

If the screen is blank, you need to charge the handset without interruption 
for at least 0 minutes to give the handset enough charge to use the 
telephone for a short time. The screen shows 

Low battery until you have 

charged the battery without interruption for at least 0 minutes. The 
following table summarizes the battery charge indicators and actions to take.

The screen is blank or shows 
Place in charger.

Battery has no or very little 
charge. The handset cannot 
be used.

Charge without interruption 
until the screen shows  
Low battery or HANDSET X 
(at least 0 minutes).

The screen shows  

Low battery and   flashes.

Battery has enough charge to 
be used for a short time.

Charge without interruption 
until the screen shows 
HANDSET X (at least  
0 minutes).

The screen shows 

HANDSET X 

and the battery icon shows  

,   or  .

Battery is charged.

To keep the battery charged, 
place it in the telephone base 
or charger when not in use.

If you are on a call in low battery mode, you hear four short beeps every 50 seconds.
When you place the handset in the telephone base or charger, if no battery is installed 
in that handset, the 

CHARGE light is off and the screen shows NO BATTERY. Follow the 

instructions in 

Battery installation on page  to install the battery.

•
•

Battery status icon

HANDSET 1

11/20

10:30

PM