bobcat s205 User Manual

Stop the engine.

Open the rear door and disconnect the negative (-) cable
from the battery.

Remove three belt shield fasteners and remove the belt
shield.

Loosen the bolt (1) [Figure 174] on the spring loaded
drive idler.

[Figure 174] when the belt tensioner is not
under spring tension.

Push the idler pulley against the belt, using a pry bar
[Figure 175]. The pointer will be at the 3 o'clock
position (1) [Figure 175] when the idler pulley is against
the stop (maximum movement).

Raise the idler assembly slightly so that the pulley is
operating on spring tension and not against the stop.

Tighten the mounting bolt (1) [Figure 174] to 34-38 Nm
torque.

Run the engine for a few minutes. Stop the engine and
recheck the pointer position.

Readjust if necessary.

After the idler has been in service, readjust when the
pointer reaches the 1 o'clock position.

Install the belt shield and fasteners.

Connect the negative (-) battery cable.

Close the rear door.

Follow the steps above to loosen the drive belt tensioner.

Remove the bolt (1) [Figure 174] from the tensioner and
remove the tensioner assembly.

Remove the fan drive belt.

Remove the drive belt from the pump pulley and flywheel
and remove the belt from the loader.

Install the new drive belt. Install the belt tensioner
assembly.

Install the fan drive belt.

Adjust the drive belt, reinstall previously removed
components and continue procedure from Belt
Adjustment above.

P-48478A

P-48479A