bobcat s205 User Manual
S205 Skid-Steer Loader
Operation & Maintenance Manual
Operation & Maintenance Manual
32
Figure 63
(ACS) Select hand control or foot pedal operation (1)
[Figure 63].
[Figure 63].
OR
(SJC) Select ‘ISO’ or ‘H’ Control Pattern (2) [Figure 63].
Figure 64
Press the PRESS TO OPERATE LOADER Button (1)
[Figure 64] to activate the BICS system and to perform
hydraulic and loader functions. (See Cold Temperature
Starting on Page 32.)
[Figure 64] to activate the BICS system and to perform
hydraulic and loader functions. (See Cold Temperature
Starting on Page 32.)
NOTE: (SJC) The pending mode will flash which will
indicate PRESS TO OPERATE LOADER is
required. The light will flash when key is ON
and continue to flash until the PRESS TO
OPERATE LOADER button is pressed and
thereafter it will light solid. If the mode
(ISO / H) is changed while driving, the active
mode will be solid and the pending mode will
flash. When operation of the machine is
returned to neutral, the active mode will then
turn off and the pending mode will continue to
flash until the PRESS TO OPERATE LOADER
button is pressed.
required. The light will flash when key is ON
and continue to flash until the PRESS TO
OPERATE LOADER button is pressed and
thereafter it will light solid. If the mode
(ISO / H) is changed while driving, the active
mode will be solid and the pending mode will
flash. When operation of the machine is
returned to neutral, the active mode will then
turn off and the pending mode will continue to
flash until the PRESS TO OPERATE LOADER
button is pressed.
WARNING
When an engine is running in an enclosed area, fresh
air must be added to avoid concentration of exhaust
fumes. If the engine is stationary, vent the exhaust
outside. Exhaust fumes contain odorless, invisible
gases which can kill without warning.
air must be added to avoid concentration of exhaust
fumes. If the engine is stationary, vent the exhaust
outside. Exhaust fumes contain odorless, invisible
gases which can kill without warning.
W-2050-1285
Cold Temperature Starting
WARNING
Do not use ether with glow plug (preheat) systems.
Explosion can result which can cause injury, death,
or severe engine damage.
Explosion can result which can cause injury, death,
or severe engine damage.
W-2071-0903
If the temperature is below freezing, perform the following
to make starting the engine easier:
to make starting the engine easier:
•
Replace the engine oil with the correct type and
viscosity for the anticipated starting temperature.
viscosity for the anticipated starting temperature.
•
Make sure the battery is fully charged.
•
Install an engine heater, available from your Bobcat
Loader dealer.
Loader dealer.
NOTE: The LCD of the Keyless Panel may not be
immediately visible when the temperature is
below -26°C (-15°F). It may take 30 seconds to
several minutes for the Display Panel to warm
up. All systems remain monitored even when
the display is off.
below -26°C (-15°F). It may take 30 seconds to
several minutes for the Display Panel to warm
up. All systems remain monitored even when
the display is off.
B-15993C
SJC
2
B-15993H
FRONT ACCESSORY PANEL
ACS
1
B-15551
1