bobcat s205 User Manual
S205 Skid-Steer Loader
43
Operation & Maintenance Manual
Removing
Lower the lift arms and put the attachment flat on the
ground and lower or close the hydraulic equipment.
ground and lower or close the hydraulic equipment.
•
If the attachment is hydraulically controlled
(combination bucket, backhoe, etc.):
(combination bucket, backhoe, etc.):
Stop the engine and relieve hydraulic pressure in the
auxiliary circuit. (See Relieve Hydraulic Pressure
(Loader and Attachment) on Page 23.)
auxiliary circuit. (See Relieve Hydraulic Pressure
(Loader and Attachment) on Page 23.)
Exit the loader and disconnect the hydraulic hoses
from the attachment.
from the attachment.
Enter the loader.
Perform the PRE-STARTING PROCEDURE. (See
PRE-STARTING PROCEDURE on Page 27.)
PRE-STARTING PROCEDURE on Page 27.)
Start the engine.
Release the parking brake.
Figure 87
Push and hold the BOB-TACH “WEDGES UP” Switch
(Front Accessory Panel) (1) [Figure 87] until the wedges
are fully raised.
(Front Accessory Panel) (1) [Figure 87] until the wedges
are fully raised.
Tilt the Bob-Tach forward.
Figure 88
Move the loader backward, away from the bucket or
attachment [Figure 88].
attachment [Figure 88].
NOTE: The Power Bob-Tach system has continuous
pressurized hydraulic oil to keep the wedges
in the engaged position and prevent
attachment disengagement. Because the
wedges can slowly lower, the operator may
need to reactivate the switch (WEDGES UP)
before installing an attachment to be sure
both wedges are fully raised before installing
the attachment.
in the engaged position and prevent
attachment disengagement. Because the
wedges can slowly lower, the operator may
need to reactivate the switch (WEDGES UP)
before installing an attachment to be sure
both wedges are fully raised before installing
the attachment.
P-16045
1
B-15993
N-18515