Microboards Technology gx-1 User Manual

 

The next step is to load your GX-1 Disc Publisher with output discs.  The system will accept CD or 
DVD 120 mm (12 cm) inkjet printable discs.  If the disc does not have an inkjet printable surface, the 
ink will not adhere to the surface of the disc.  The GX-1 Disc Publisher will only accept 12 cm discs.  
Business card or 8 cm discs are not supported by this system. 

 

      

 

 

 

 

 

 

    Figure 1 

 

 

 

 

                Figure 2 

Load the first 5 or 6 discs flat, as seen in figure 1. 

Load the rest of the discs at an angle, against the wide input rod, as seen in figure 2. 

The GX-1 Disc Publisher will hold a maximum of 50 discs.  DO NOT load more than 50 discs in the 
system, as this may cause the discs to feed incorrectly. 

1.  Cancel Button – Pressing the Cancel button cancels the current print job. 

2.  Print Button – The light on this button will flash when printing is in progress. 

3.  OK Button – This button will only be used when you are prompted to do so while processing 

discs. 

4.  Power Button and Light – The Power button turns the GX-1 Disc Publisher on and off.  It may 

take a few seconds for the GX-1 Disc Publisher to turn on after you press the Power button.  
The green light at the base of the Power button flashes when the printer is processing. 

NOTE: The AC power switch located on the back of the GX-1 Disc Publisher must be turned on first 
in order to supply power to the Front Panel.