U-Line CO2075FF User Manual

02/2005

www.U-LineService.com

™

For a complete refreshment center, install your CO2075FF 
Ice Maker/Refrigerator beside a U-Line Drawer or Wine 
Captain Model (see Figure 11 for typical cut-out). Note 
that each Side-By-Side Installation will be different.

• Cut-out width for a side-by-side installation is the total 

of the widths listed under Cut-Out Dimensions in each 
unit’s Installation Guide. 

Placing a CO2075FF Ice Maker/Refrigerator next to a 
2015 series unit would require a cut-out width of:
24-3/16" + 15-3/16" = 39-3/8"

Placing a CO2075FF Ice Maker/Refrigerator next to a 
2075 series unit would require a cut-out width of:
24-3/16" + 24-3/16" = 48-3/8"

• No trim kit is required. However, 1/4-inch space needs to 

be maintained between the units to ensure 
unobstructed door swing.

• Units must operate from separate, properly grounded 

electrical receptacles placed according to each unit’s 
Electrical Specifications.

 

(Black and White Units Only)

Two types of custom door panels can be installed on your 
Black or White unit to harmonize with or accent the 
surrounding décor: a Custom 1/4" Insert or a Full Overlay. 
If no custom door panel is used, go on to 5 Adjust Door.

A custom door panel can be inserted into the doorframe. 
Custom door panels can be flat or raised, as long as the 
maximum panel thickness where inserted into the door 
reveal (channel) is 1/4"-thick. For raised panels, the depth 
of the reveal is 1/4" on all four sides.

Raised panels will reduce the door’s 90° swing/zero 
clearance if the unit is installed next to a wall or similar 
type of structure (see Page 5).

Cut the panel insert to the following dimensions.

Custom 1/4" Dimensions:

Width:

23-1/32"

Height:

28-5/32"

The door panel must not weigh more than 20 lbs.

Install the insert as follows:

1. Remove the door shelves by first pulling shelves 

up at a 45° angle then straight out (see Figure 37 on 
Page 15).

Use care when handling the insert. Insert edges may be 
sharp.

2. Remove top hinge screw pin (7/64" Allen wrench or 

Phillips screwdriver, depending on your unit’s 
construction, see Figure 12). Remove door by tilting 
forward and lifting off bottom hinge pin.

1-1/2"

7"

34-1/4"

to

35-1/8"

1/4" Space

Between

Appliances

23-11/16"