U-Line BI2015 User Manual

02/2005

www.U-LineService.com

Route notch in top corner of overlay panel as shown 
(see Top and Side Views). Top of notch is entire depth 
of panel, front to back. 

Width: 13/16"

Depth: 1/8"

Route notch in backside of top corner of overlay panel 
(see Back and Side Views). 

Width: 13/16"

Depth: 1/8"

Height: 1-17/32" from top edge of panel (less 1/8" for 
depth of notch on top of panel)

Radius of corner notch: 1/8" (see Back View)

3. Drill holes for pivot plate mounts (see Figure 16, Back 

View).

5/16" diameter x 1/2" deep, from the routed surface 

Be careful not to drill too deep! Drilling holes too deep 
may destroy your door panel.

4. Drill hole for upper door hinge (top of panel) (see 

Figure 16, Top View).

0.177" diameter

(#16 drill) x 11/16" deep

5. Drill hole for lower door hinge (see Figure 16, Bottom 

View).

5/16" diameter x 1/4" deep

It is important to ensure that all drilled holes are drilled to 
the correct depth in order to avoid splits in the wood 
when hardware is installed.

1. Remove top hinge screw pin (7/64" hex key or Phillips 

screwdriver, depending on your unit’s construction). 
Remove the door by tilting forward and lifting off the 
bottom hinge pin.

2. Pull door gasket out of the groove (top edge of door 

only). Start in the middle and pull outward, moving 
toward the edge (see Figure 17). This may take some 
force.

3. Remove the three screws located on the back of the 

handle (see Figure 18).

13/16"

1-17/32"

13/16"

13/32"

3/8"

Door Bottom:

5/16" Dia. x 1/4" Deep

Chamfer 1/32" x 45

°

3/8"

1/8"

1/8"

13/16"

7/16"

1/8"

13/32"

3/4"

13/32"

0.177" Dia. (#16 Drill)

x 11/16" Deep

5/16" Dia.

x 1/2" Deep

1/32" R

1/8" R

Old Handle

New Handle