Cadillac cts User Manual

To change the mode using the Navigation system, do the
following:

1. Enter the Personalization menu following the

instructions listed previously.

2. Scroll to Twilight Delay using the TUNE/SEL knob

to highlight it.

3. Press the TUNE/SEL knob to turn Twilight Delay on

or off. If the feature is turned off, the exterior lamps
will not illuminate at all when you exit the vehicle.

Once the feature is turned on, the modes listed above
will appear on the display, and the currently selected
time delay will have an X in the box to the left.

4. Turn the TUNE/SEL knob until you reach the

desired time delay.

5. Press the TUNE/SEL knob once to select 

your choice.

When a time is selected, an X will appear next to the
time delay you chose. Only one mode can be
selected at a time.

The mode you selected is now set. You can either exit
the programming mode by following the instructions
later in this section or program the next feature available
on your vehicle.

This feature turns on the exterior lamps when the remote
keyless entry transmitter is used to unlock the vehicle.
The lamps will remain on for approximately 20 seconds
unless a door is opened, the ignition is turned to
ACCESSORY, ON or START or the remote keyless
entry transmitter is used to lock the vehicle.

Mode 1: ON

Mode 2: OFF

Before your vehicle was shipped from the factory, it was
programmed to Mode 1. The mode to which the vehicle
was programmed may have been changed since it left
the factory. To determine the mode to which the vehicle
is programmed or to program the vehicle to a different
mode, use one of the following procedures:

To change the mode using the Base audio system, do the
following:

1. Enter the personalization portion of the SETUP

menu following the instructions listed previously.

2. Scroll to LIGHTS FLASH AT UNLOCK to

highlight it.