DB Link db drive dba1600.1d User Manual

DJUSTMENTS AND SETTINGS

The “DBA Series” amplifiers are equipped with built-in variable crossover networks allowing

you to select the crossover mode (i.e. Low-Pass/Full/High-Pass or On/Off) and the desired

crossover point. For example if you wish to drive a pair of subwoofers, you can select the

“Low Pass” setting on the amplifier to filter out high frequencies. This will send only low

frequencies to your subwoofers (see example settings below). The crossover point should

be determined by the speakers operating range. Please refer to speaker manufactures

recommended crossover point.

INE TUNE THE SYSTEM

Fine tune the amplifier’s input sensitivity

The gain sensitivity control for the “DBA Series” amplifier is located on the side panel. This

gain control has been included to allow adjustment to properly match the output of the radio.

This is one of the most misunderstood adjustments. By rotating the control in the clockwise

direction, the amplifier’s input will become more sensitive and the music will play louder.

This is not a volume control and you will not get more power out of the amplifier in the

maximum position! It may seem to deliver more output, but actually the system is only

playing louder faster as you turn the volume control on the radio. Ideally, to properly level

match the system the goal is to achieve maximum output from the amplifier without distor-

tion at about ¾ of the volume control.

To determine if the amplifier’s gain is set properly, turn the system on and slowly increase

the volume control. You should be able to use about ¾ volume before the system gets loud

but not distorting. It is very important when making these adjustments that you do not over

drive the speakers (at point of distortion) this will cause permanent damage to the speakers.

If you are unable to achieve ¾ volume before distortion you will need to adjust gain control

(in this case you would reduce the gain). The gain controls should be adjusted very slowly.

It may help to have another person to assist you by adjusting the gain controls while you

listen for distortion.

Input Level

Adjust the frequency to the

desired point for speakers 3 & 4.

Adjust the frequency to the

desired point for speakers 1 & 2 .

Filter selection for channel 3 & 4

Filter selection for channel 1 & 2

Min

Max

0 6 12