jetway 2user-qig-miniq-r1.1 User Manual

 
 
 

                                                                                                                                                                                                                                                                                                                                       
 

Push the CPU socket lever sideway out and lift up to 90° angle.  
Locate Pin 1 on the socket and align cut edge of the CPU to it. Insert the CPU onto the socket, 
press the CPU from top evenly by hand, and pull back the CPU socket lever to lock the CPU in 
position. Apply thermal tape (recommended) or thermal paste to provide better heat conduction 
between CPU and heatsink. Make sure the heatsink is in good contact with CPU to avoid over-
heat or damage. Please use an Intel or AMD approved CPU cooling system. Connect the CPU 
fan power cable to fan connector on motherboard. Plug the cooling system (heatsink and cooling 
fan) to the CPU retention module in correct direction. Follow the instructions and precautions 
from CPU, heatsink and cooling fan to complete the installation. 

 

 

 
 

 

 
 
 

Loosen screw and pull out the HDD bracket from its rail. Place HDD onto the correct position on 
the bracket and screw to fix the HDD. Slide back the bracket with HDD on to its rail and tighten 
the screw. Connect HDD cable from IDE1 connector on motherboard to HDD. The HDD cable 
comes with three connectors. Always use the first two connectors for the first HDD connection. 
Make sure the red stripe of the cable is aligned to the pin 1 of connector. Insert firmly to insure 
the contact. (If Serial ATA is supported on the motherboard, just connect the Serial ATA cable 
come packaged with the accessory box to HDD and motherboard). Connect power cable to 
power connector on HDD.