AudioControl LC6i Owner's Manual
page 12
Figure 8: Dash Control Assembly
Dash Bracket Installation
The dash control mounts with two screws, which attach
The dash control mounts with two screws, which attach
to the underside of the dashboard. Slide under the
dash and place the dash control in its mount-
ing position, mark the two mounting holes,
drill pilot holes, and secure with two
screws.
dash and place the dash control in its mount-
ing position, mark the two mounting holes,
drill pilot holes, and secure with two
screws.
Custom Installation
For that custom, nished look,
For that custom, nished look,
the dash control can be ush
mounted directly on the dash-
board (or anywhere else). We have
provided an extra label to help make this happen. Referencing Figure 8,
disassemble the dash control from the mounting bracket. Start by push-
ing the LED from its holder followed by removing the circuit board and
rotary control from the bracket. Drill a 9/32 hole in the dashboard for
the control along with a 1/8 hole for the lock tab and a 13/64 hole for the
LED holder. Reassemble the dash control components on the dashboard
and apply the new label over the openings
mounted directly on the dash-
board (or anywhere else). We have
provided an extra label to help make this happen. Referencing Figure 8,
disassemble the dash control from the mounting bracket. Start by push-
ing the LED from its holder followed by removing the circuit board and
rotary control from the bracket. Drill a 9/32 hole in the dashboard for
the control along with a 1/8 hole for the lock tab and a 13/64 hole for the
LED holder. Reassemble the dash control components on the dashboard
and apply the new label over the openings
Dual-Color Dash Control LED
The LED on your dash control is rainforest green and should brighten
The LED on your dash control is rainforest green and should brighten
or dim when you turn the knob. Should you wish to change the color to
amber, remove the plug connected to the LED and turn it 180 degrees
and plug it back in.
amber, remove the plug connected to the LED and turn it 180 degrees
and plug it back in.
Troubleshooting
It is important to remember when installing your LC6i that the engi-
neers who work for the car manufacturers don’t spend too much time
thinking about interfacing after market products. Therefore you will
most likely have to “modify” your traditional wiring and installation
techniques when working with these types of systems. Many times tradi-
tional 12 volt “turn-on” wires or pre-amp audio signals that you are used
to with aftermarket systems don’t exist on these newer vehicles.
thinking about interfacing after market products. Therefore you will
most likely have to “modify” your traditional wiring and installation
techniques when working with these types of systems. Many times tradi-
tional 12 volt “turn-on” wires or pre-amp audio signals that you are used
to with aftermarket systems don’t exist on these newer vehicles.
No Power: If the Power LED on your LC6i will not turn on, check to
make sure that the power wire and remote turn-on wires are connected or
a fuse has not blown, and that your factory headunit is on!
a fuse has not blown, and that your factory headunit is on!
LC6i Turns Off Intermittently: If you are using the GTO signal sens-
ing to turn on your LC6i yet your system is turning off, this may be due
to a cellular phone interface or navigation system built in to your factory
installed source unit. These are known to route the audio signal away
from your source unit’s outputs. In these situations it is recommended
that you connect a 12-volt trigger wire from the Remote In on the LC6i.
to a cellular phone interface or navigation system built in to your factory
installed source unit. These are known to route the audio signal away
from your source unit’s outputs. In these situations it is recommended
that you connect a 12-volt trigger wire from the Remote In on the LC6i.