Autostart AS2201 User Manual

P. 2 

User Guide

 AS-1412 

Transmitter Part Number and Serial Number of the Remote Car Starter Module 

The boxes below contain information concerning your transmitter and Remote Car Starter. 

We entered the part number of your transmitter for you. Should you need to order a new 

transmitter, you will need to provide the transmitter part number which is printed below. 

The second box contains the serial number of the Remote Car Starter. Please make sure 

that the installer has entered the serial number in that box. 

The installer must use the space below to write the serial number of the Remote Car Starter 

and the location of the valet switch (if installed): 

Serial Number of the Remote Car Starter: 
Location of the Valet Switch (if installed): 

Introduction 

This Module is a state-of-the-art remote car starter system. With many advanced function, 

this product will satisfy any one of the user’s expectations from high-end commodity systems, 

without neglecting the standard features commonly offered by entry-level starters. 

Remote-starting Your Vehicle 

Press the 

ΙΙ button for approx. 1 second. The parking lights will come on, informing you that 

the unit has received your signal. Approx. 5 seconds later, the engine will start. The parking 

lights will remain on during the pre-programmed run time. 

If the vehicle doesn’t start the first time, the system will shut down, wait a few seconds, and 

try to start the engine again. It will try to start the engine 3 times before giving up. 

Vehicle Presets 

When leaving the vehicle it is recommended to preset the accessory controls in preparation 

for the next remote start.  Settings for the blower motor (fan), front and rear, as well as 

heated seats (if equipped) should not be left on 

.  It is recommended to leave the settings 

on 

 or 

 instead. 

Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to 

become energized while running under remote start.  When leaving the vehicle you must 

ensure that the windshield wiper and headlight switches are 

.  Leaving the headlight 

switch on on certain types of vehicles could cause them to remain on even after the remote 

starter shuts down, resulting in a dead battery. 

Driving Off 

With the vehicle running under remote control, press button 

Ι to 

 the module and to 

 the doors (if installed). Enter the vehicle and do the following: 

•  Turn the ignition key to the 

 position. 

•  Press the brakes to disengage the remote starter unit. 

You are now ready to drive off. 

Caution: do not turn the key to the 

 position with the engine running. This will cause 

the starter motor to re-engage, unless your vehicle is equipped with the Start Kill / Anti-

Grind Feature (Optional). 

Idle Mode 

This feature allows the user to engage the remote starter to take over the vehicle while it is 

already running with the key in the 

switch. The vehicle will keep running for the pre-

programmed run time, or until it is shut down by remote.