Buffalo 000000013 User Manual
5
Notes:
• WZR-900DHP has an USB 3.0 port and WZR-600DHP2 has an USB 2.0 port.
• USB 3.0 hubs are not supported. Use USB 2.0 hubs only.
• WZR-900DHP has an USB 3.0 port and WZR-600DHP2 has an USB 2.0 port.
• USB 3.0 hubs are not supported. Use USB 2.0 hubs only.
6
LAN LED (Green)
On:
An Ethernet device is connected.
Blinking:
An Ethernet device is communicating.
On:
An Ethernet device is connected.
Blinking:
An Ethernet device is communicating.
7
LAN Port
Connect your computer, hub, or other Ethernet devices to these ports. This switching hub supports 10 Mbps, 100
Mbps, and 1000 Mbps connections.
Connect your computer, hub, or other Ethernet devices to these ports. This switching hub supports 10 Mbps, 100
Mbps, and 1000 Mbps connections.
8
Internet LED (Green)
On:
The Internet port is connected.
Blinking:
The Internet port is transmitting data.
On:
The Internet port is connected.
Blinking:
The Internet port is transmitting data.
9
Internet Port
10 Mbps, 100 Mbps, and 1000 Mbps connections are supported.
10 Mbps, 100 Mbps, and 1000 Mbps connections are supported.
Note:
In bridge/AP mode (router off), the Internet port becomes a regular LAN port, for a total of 5 usable LAN ports.
In bridge/AP mode (router off), the Internet port becomes a regular LAN port, for a total of 5 usable LAN ports.
10
Power button
This button turns the power on and off.
This button turns the power on and off.
11
DC connector
Connect the included AC adapter here.
Connect the included AC adapter here.
Bottom
1
Reset button
To reset all settings, hold down this button until the Buffalo LED turns red (about 3 seconds). The power must be
on for this to work.
To reset all settings, hold down this button until the Buffalo LED turns red (about 3 seconds). The power must be
on for this to work.