TP-LINK TL-WR 841 ND User Manual

 

TL-WR841N/TL-WR841ND

 

-7- 

¾

 

Broadband Internet Access Service (DSL/Cable/Ethernet) 

¾

 

One DSL/Cable Modem that has an RJ45 connector (which is not necessary if the router is 

connected directly to the Ethernet.) 

¾

 

PCs with a working Ethernet Adapter and an Ethernet cable with RJ45 connectors   

¾

 

TCP/IP protocol on each PC 

¾

 

Web browser, such as Microsoft Internet Explorer, Mozilla Firefox or Apple Safari 

¾

 

Place the router in a well ventilated place far from any heater or heating vent   

¾

 

Avoid direct irradiation of any strong light (such as sunlight) 

¾

 

Keep at least 2 inches (5 cm) of clear space around the router 

¾

 

Operating Temperature: 0 ~40  (32 ~104 )

℃

℃

℉

℉

 

¾

 

Operating Humidity: 10%~90%RH, Non-condensing 

Before installing the router, make sure your PC is connected to the Internet through the 

broadband service successfully. If there is any problem, please contact your ISP. After that, please 

install the router according to the following steps. Don't forget to pull out the power plug and keep 

your hands dry. 

1.  Power off your PC, Cable/DSL Modem, and the router.   

2.  Locate an optimum location for the router. The best place is usually at the center of your 

wireless network. The place must accord with the 

3.  Adjust the direction of the antenna. Normally, upright is a good direction. 

4.  Connect the PC(s) and each Switch/Hub in your LAN to the LAN Ports on the router, shown in 

 2-1. (If you have the wireless NIC and want to use the wireless function, you can skip 

this step.) 

5.  Connect the DSL/Cable Modem to the WAN port on the router, shown in 

.

 

6.  Connect the power adapter to the power socket on the router, and the other end into an 

electrical outlet. The router will start to work automatically.