Fantec TC-2U50ES 80Plus 2506 User Manual

Product codes

2506

SURE STAR COMPUTER CO., LTD

No. 2-1, Daan Road, Shulin City Taipei 238 , Taiwan
E-mail: info@tc-surestar.com.tw Tel: +886 2 2682 2505
http: //www.tc-surestar.com.tw Fax: +886 2 2682 2515

MODEL : SS-2U50ES (> 80%)

1. Specification

1.1.AC Input Voltage Range: 100VAC ～ 240VAC,

10%, 47 to 63 Hz.

1.2.INPUT CURRENT:8.0 A ( RMS ) FOR 115VAC /4.0 A ( RMS ) FOR 230VAC.
1.3. Input Power Factor: The minimum power factor at full load shall be

0.98/115V 60 Hz and 0.95/230V 50 Hz.

1.4.

Inrush current: 35A MAX. FOR 115 VAC / 55A MAX. FOR 230 VAC.

1.5.DC Output: 400W maximum.

Output-1 Output-2 Output-3 Output-4 Output-5

Output Voltage

+5V DC +12V DC -12V DC +3.3V DC +5VSB

Output Current(Max)

25A

40A

0.8A

25A

3.5A

Output Current(Min.)

0.5A

0.1A

Ripple/Noise Max.(P-P)

60mv

120mv

60mV

Line Regulation

±1﹪

Load Regulation

±5﹪

Note:

1. Noise Test – Noise bandwidth is from DC to 20 MHz.
2. Ripple frequencies greater than 1MHz shall be attenuated by the measurement

System.

3.Add 0.1uF/10uF capacitor at output connector terminals for ripple and noise

measurements.

4.The combined total power from 5V & 3.3V shall not exceed 170W.

1.3 PS-ON
Remote On/Off Control:

When PS-ON is pulled to TTL Low, the DC output is to be enabled.
When PS-OFF is pulled to TTL high, the DC output is to be disabled.

1.4 PW-OK

      PW-OK is power good signal and should be asserted high by the power
      supply to indicate that +5VDC and +3.3VDC output are above the under
      voltage thresholds of the power supply TTL. compatible signal out with
      100ms to 500ms.