UTAX P-4530DN 4434500000 User Manual

Product codes
4434500000
Page of 312
Preparation before Use 
2-6
Entering the Default Gateway
When DHCP is set to Off, enter the Default Gateway manually.
23
Press  or  to select Default Gateway.
24
Press [OK]. The Default Gateway screen appears.
25
Use the numeric keys or press  or  to set the default gateway.
You can set any value between 000 and 255.
The method for entering is the same as for the IP Address.
26
Press [OK]. The default gateway is stored and the IPv4 Setting 
menu reappears.
This completes the network settings. Press [Menu] and end the 
mode selection menu.
Printing a Status Page
After completing the network settings, print a status page. The status page allows you to confirm a range of information, 
including network addresses and network protocols. 
To print a status page, select Status Page from the Report Print menu. Refer to Report Print on page 4-10 for detailed 
information.
Note  
When the network settings have been changed, restart 
the network card of the device. This is mandatory to make 
the settings effective. For details, refer to Restart Network 
(Restarting the network card) on page 4-61
.
Default Gateway: a 
 
  /**0.  0.  0.  0