Metra AX-ADXSVI-GM1 Leaflet

™

© COPYRIGHT 2004-2011  METRA ELECTRONICS CORPORATION 

•  Connect the

 Gray wire to the right front positive speaker output of the

aftermarket radio.

•  Connect the

Gray/Black wire to the right front negative speaker output of the

aftermarket radio.

•  Connect the

Green wire to the radio’s left rear positive speaker output.

•  Connect the

Green/Black wire to the radio’s left rear negative speaker output.

•  Connect the

Purple wire to the radio’s right rear positive speaker output.

•  Connect the

Purple/Black wire to the radio’s right rear negative speaker output.

The following wires are for the aftermarket radios that have navigation built in.
•  Connect the

Light Green wire to the parking brake wire of the aftermarket navigation

radio (if applicable).

•  Connect the

 Blue/Pink wire to the VSS or speed sense wire of the aftermarket

navigation radio (if applicable).

•  Connect the

Green/Purple wire to the reverse wire of the aftermarket navigation radio

(if applicable).

•  Cycle the key, by turning the ignition on for 30 seconds. Then off and on again to test

the radio.

After the XSVI is initialized, plug in the ASWC-1 into the 12-pin harness of the AX-ADXSVI-
GM1 and refer to the ASWC-1 instructions.

Enhance your installation and fabrication skills by 

enrolling in the most recognized and respected 
mobile electronics school in our industry.
Log onto www.installerinstitute.com or call 
800-354-6782 for more information and take steps 
toward a better tomorrow.

This product includes instructions for installation which must be carefully followed. The

instructions are worded in such a manner to assume that the installer is capable of

completing these type of electronic installations. If you are unclear as to what you are

instructed to do or believe that you do not understand the instructions so as to properly

and safely complete the installation you should consult a technician who does have this