Janitza Prodata 2 5224001 Data Sheet
Product codes
5224001
27
ProData II
DIP switch S1
If the ProData 2 is integrated into a bus via the RS485
interface, a termination resistor has to be set (see
the RS485 interface, termination resistors chapter)
depending on the placement of the ProData within
the segment.
interface, a termination resistor has to be set (see
the RS485 interface, termination resistors chapter)
depending on the placement of the ProData within
the segment.
Termination within the device is possible via the S1 DIP
switch of the ProData 2.
switch of the ProData 2.
Service button S2
The service button is only to be used by instructed
service employees and must not be pressed by those
who are not acquainted with it.
service employees and must not be pressed by those
who are not acquainted with it.
LED device status
The status LEDs below the RS485 interface show
different states of the device. During the start process,
the red and the green LEDs illuminate at the same time.
Once the start process is complete (approximately
15 seconds), the red LED illuminates; the green LED
indicates flawless operation of the device.
different states of the device. During the start process,
the red and the green LEDs illuminate at the same time.
Once the start process is complete (approximately
15 seconds), the red LED illuminates; the green LED
indicates flawless operation of the device.
LED
Function
Red/Green Shows the initialisation process during
the start phase (approx. 15 seconds)
Green
Device is operational
Red
Device error
Red/Green If the start process is complete
and both LEDs are still illuminated,
the initialisation process was
interrupted. Perform a device update
(firmware) via the software.
the initialisation process was
interrupted. Perform a device update
(firmware) via the software.
LED device status