Technoline WS 8005 Radio controlled wall clock WS 8005 Data Sheet

WS 8005 Manual 

ALARM button to confirm your setting 

` The Minute display of the Alarm time starts to flash. Use the “▲” and “▼“buttons to set the required minute. Press 

ALARM button to confirm your setting and to end the setting procedure. 

` To activate or deactivate the daily alarms, briefly press the “ALARM” button once. 

` After 30 seconds without pressing any button the clock switches automatically from setting mode to Normal clock 

mode. 

` The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In this case the alarm will be 

repeated automatically after 24 hours. 

` Rising alarm sound changes the frequency 4 times while the alarm signal is heard. 

` Proceed as follows to activate the automatic Snooze function: While the alarm is sounding, press the SNOOZE 

button to activate snooze function. Then Snooze function is active. The “



” icon appears on the display. 

` This operation moves the alarm back by 5 minutes and the alarm will restart at this time. 
` The Snooze function can be interrupted by pressing any button. 

` The temperature is displayed either in °C or °F. Briefly pressing the “▼ “button allows you to switch between the 

individual models. 

`  The clock automatically starts the DCF signal search after 7 minutes of any restart or changing of new fresh 

batteries. The radio mast icon starts to flash. 

` At 1:00 am, the clock automatically carries out the synchronization procedure with the DCF signal to correct any 

deviations to the exact time. If this synchronization attempt is unsuccessful (the radio mast icon disappears from 

the display), the system will automatically attempt another synchronization at the next full one hour. This procedure 

is repeated automatically up to total 5 times.   

` To start manual DCF signal reception, press the “WAVE“ button. If no signals received within 7 minutes, then the 

DCF signal search stops (the radio mast icon disappears) and start again at the next full one hour.   

` During RC reception，to stop searching radio signal, press the “WAVE“ button once. 

` A flashing radio mast icon indicates that the DCF signal reception has started 
` A continuously displayed radio mast icon indicates that the DCF signal was received successfully 
` We recommend a minimum distance of 2.5 meters to all sources of interference, such as televisions or computer 

monitors 

` Radio reception is weaker in rooms with concrete walls (e.g.: in cellars) and in offices. In such extreme 

circumstances, place the system close to the window.