Atmel MCU Evaluation Kit AT32UC3L-EK AT32UC3L-EK Data Sheet
Product codes
AT32UC3L-EK
4
AVR32777
3 Touch Demonstration firmware communicating with Atmel AVR QTouch
Studio
Requirements:
• Atmel AT32UC3L-EK rev2
• Atmel AVR QTouch Studio v4.2 (or higher)
The default pre-loaded demonstration firmware on the AT32UC3L-EK allows
controlling the LEDs with the on-board touch sensors. If the kit is connected to a PC
with AVR QTouch Studio installed and up and running, the on-board touch events are
represented visually in the Virtual Kit View tab as a solid green disc or in the QTouch
Graph View tab.
• Atmel AVR QTouch Studio v4.2 (or higher)
The default pre-loaded demonstration firmware on the AT32UC3L-EK allows
controlling the LEDs with the on-board touch sensors. If the kit is connected to a PC
with AVR QTouch Studio installed and up and running, the on-board touch events are
represented visually in the Virtual Kit View tab as a solid green disc or in the QTouch
Graph View tab.
The demonstration can be used in a basic environment setup (only the AT32UC3L-
EK rev2 powered with a battery (included with the kit)) or in a more advanced
environment setup (the AT32UC3L-EK rev2 connected to a PC through USB, with
AVR QTouch Studio installed on the PC). In the latter setup, all touch events on the
UC3L are sent to AVR QTouch Studio through USB (the on-board Atmel
AT32UC3B1256 device acting as a UART to USB gateway).
EK rev2 powered with a battery (included with the kit)) or in a more advanced
environment setup (the AT32UC3L-EK rev2 connected to a PC through USB, with
AVR QTouch Studio installed on the PC). In the latter setup, all touch events on the
UC3L are sent to AVR QTouch Studio through USB (the on-board Atmel
AT32UC3B1256 device acting as a UART to USB gateway).
Figure 3-1. Overview of the demonstration
32149A-AVR-07/10
Touch events have an
effect on the LEDs.
AVR QTouch Studio 4.2
or higher
USB