Atmel Evaluation Kit AT91SAM9X35-EK AT91SAM9X35-EK Data Sheet
Product codes
AT91SAM9X35-EK
384
SAM9X35 [DATASHEET]
11055E–ATARM–10-Mar-2014
29.12.3 Ready Mode
In Ready mode (EXNW_MODE = 11), the SMC behaves differently. Normally, the SMC begins the access by down
counting the setup and pulse counters of the read/write controlling signal. In the last cycle of the pulse phase, the
resynchronized NWAIT signal is examined.
counting the setup and pulse counters of the read/write controlling signal. In the last cycle of the pulse phase, the
resynchronized NWAIT signal is examined.
If asserted, the SMC suspends the access as shown in
. After deassertion, the access is
completed: the hold step of the access is performed.
This mode must be selected when the external device uses deassertion of the NWAIT signal to indicate its ability to
complete the read or write operation.
complete the read or write operation.
If the NWAIT signal is deasserted before the end of the pulse, or asserted after the end of the pulse of the controlling
read/write signal, it has no impact on the access length as shown in
read/write signal, it has no impact on the access length as shown in
Figure 29-28.NWAIT Assertion in Write Access: Ready Mode (EXNW_MODE = 11)
EXNW_MODE = 11 (Ready mode)
WRITE_MODE = 1 (NWE_controlled)
WRITE_MODE = 1 (NWE_controlled)
NWE_PULSE = 5
NCS_WR_PULSE = 7
NCS_WR_PULSE = 7
A
[25:2]
MCK
NWE
NCS
4
3
2
1
0
0
0
4
5
6
3
2
1
1
1
0
Write cycle
D[31:0]
NWAIT
internally synchronized
NWAIT signal
Wait STATE
NBS0, NBS1,
NBS2, NBS3,
A0,A1
NBS2, NBS3,
A0,A1