Reely RC model speedboat ARR 935 mm BM301A Data Sheet
Product codes
BM301A
32
9. Operating the Model
a) Inserting the Drive Battery
Open the body cover.
The drive battery (1) must be attached to the bottom
of the body with hook-and-loop tape so that it will be
kept secure in its position even in rough operation.
of the body with hook-and-loop tape so that it will be
kept secure in its position even in rough operation.
The battery should be mounted as close to the motor
(2) as possible for best running properties.
(2) as possible for best running properties.
Observe tight fit of the rechargeable battery. We recommend that the battery be attached to the wood board
with an additional strip of hook-and-loop tape taped into the battery box, rather than only those present. The
material required for this is not part of the delivery and must be procured separately.
with an additional strip of hook-and-loop tape taped into the battery box, rather than only those present. The
material required for this is not part of the delivery and must be procured separately.
b) Connecting the Drive Battery
Switch on the transmitter and set the trimming of all control functions to the neutral position. Observe the information
and instructions in the operating instructions of the remote control system.
and instructions in the operating instructions of the remote control system.
Place the boat on a suitable surface (e.g. on the included boat rack) so that the ship’s propeller can move freely.
Connect the plug connections on the driving battery to the counter-piece of the speed controller.
Connect the plug connections on the driving battery to the counter-piece of the speed controller.
The speed controller starts to initialise at once. When everything is just right, this is indicated with a brief signal sound.
The speed controller is now ready for operation. In this case, undervoltage recognition is not programmed. Also
observe the notes in chapter „Programming the speed controller“.
The speed controller is now ready for operation. In this case, undervoltage recognition is not programmed. Also
observe the notes in chapter „Programming the speed controller“.
If several signal sounds (e.g. 3x beeps) are reported acoustically, the speed controller is ready for operation as well. In
this case, however, it is signalled that the speed controller is programmed for operation with a 3-cell LiPo battery and
an undervoltage recognition. Also observe the notes in chapter „Programming the speed controller“.
this case, however, it is signalled that the speed controller is programmed for operation with a 3-cell LiPo battery and
an undervoltage recognition. Also observe the notes in chapter „Programming the speed controller“.
If successful initialisation is not reported acoustically, the speed controller is not ready for operation either. In
this case, carefully adjust the speed control trimming at the transmitter (see operating instructions of the
remote control system) until the sound signals are issued. You may also need to remove the drive battery for
this. It must be reconnected after approx. 10 seconds. When this measure does not lead to success, the
neutral position for the drive function must be programmed. Also observe the notes in chapter „Programming
the speed controller“.
this case, carefully adjust the speed control trimming at the transmitter (see operating instructions of the
remote control system) until the sound signals are issued. You may also need to remove the drive battery for
this. It must be reconnected after approx. 10 seconds. When this measure does not lead to success, the
neutral position for the drive function must be programmed. Also observe the notes in chapter „Programming
the speed controller“.
Figure 4