Conrad 12 Vdc delayed action timer relay module 193631 Data Sheet
Product codes
193631
Attention! Read carefully!
The
warranty
claim
shall
lapse
with
damages caused due
to
failure to
follow instructions.
This timer relay serves the purpose of switching on and off the devices. The timer is
activated when the control voltage is supplied and is again deactivated after the course
of easily adjustable interval time (switch off delay). If the coding plug is adjusted
on switch on delay, then the set time progresses with the supply of operating voltage
(Relay is still in idle position). The relay is activated after the course of delay time. The
relay is again switched back to the idle position with any interruption in
control voltage. The switch status (supplied control voltage, activated relay) is
displayed via LEDs.
This article has been tested as per the EC guidelines 89/336/EEC (Electromagnetic
Compatibility Law, dated, 09.11.1992) and complies with the statutory requirements.
Technical data:
This timer relay serves the purpose of switching on and off the devices. The timer is
activated when the control voltage is supplied and is again deactivated after the course
of easily adjustable interval time (switch off delay). If the coding plug is adjusted
on switch on delay, then the set time progresses with the supply of operating voltage
(Relay is still in idle position). The relay is activated after the course of delay time. The
relay is again switched back to the idle position with any interruption in
control voltage. The switch status (supplied control voltage, activated relay) is
displayed via LEDs.
This article has been tested as per the EC guidelines 89/336/EEC (Electromagnetic
Compatibility Law, dated, 09.11.1992) and complies with the statutory requirements.
Technical data:
Control voltage ................. : 12, 24V= ± 10%
Rated consumption ............ : approx. 1 W
Rated current ................... : 12V 75 mA, 24 V approx. 40 mA
Equipment .................. : 1 Relay with 1 changeover contact
Switch voltage ........... : 250 V AC
Rated current ................... : 5 A
Max. Switching output ..... : (ohm load) 1100 VA~
Rated consumption ............ : approx. 1 W
Rated current ................... : 12V 75 mA, 24 V approx. 40 mA
Equipment .................. : 1 Relay with 1 changeover contact
Switch voltage ........... : 250 V AC
Rated current ................... : 5 A
Max. Switching output ..... : (ohm load) 1100 VA~
(ohmic load in W)
24V = 120
48V = 75
20V = 30
INSTALLATION
The on and off switch delay time is set up with the
help of a small screwdriver with P1 trimmer
potentiometer.
PROGRAMMING
Switching OFF delay
If the link plug is plugged in the 3-pin multi-pin
connector at "AV" = switching off delay, then the
relay is immediately activated with the supply of
control voltage. The timer is deactivated after the
The on and off switch delay time is set up with the
help of a small screwdriver with P1 trimmer
potentiometer.
PROGRAMMING
Switching OFF delay
If the link plug is plugged in the 3-pin multi-pin
connector at "AV" = switching off delay, then the
relay is immediately activated with the supply of
control voltage. The timer is deactivated after the