Conrad 16-Channel Running Light Controller Module 190486 Data Sheet

After installing the C-Control software and assigning the COM port to the interface used, you
can connect the 16-channel running light control to the PC.
Press and hold both buttons SW 1 and SW 2. Then release button SW 1 while still pressing
SW 2. Then release button SW 2 as well.
As an alternative, you can also apply the operating voltage to the 16-channel running light
control with the button SW 2 pressed.
In case of correct installation and commissioning, you will receive a message from the running
light control in the C-Control software output window. Now you can call the running light
programme under IDE and re-program it according to your ideas.



Under www.c-control.de, you will find extensive help texts in the area C-Control Pro
to help you with any problems during installation and configuration.

Clean the exterior of the 16-channel running light control only with a soft, dry cloth or brush.
Never use caustic cleaning agents or chemical solutions as the surface of the board could be
damaged. Protect the board from dirt and humidity.

At the end of its service life, dispose of the product according to the relevant
statutory regulations.