Renkforce 3D printer RF1000 Single extruder (value.974113) RF1000 Data Sheet
Product codes
RF1000
57
1. Initial Commissioning
Before initial commissioning, all transport protections or fuses that have been installed during installation must be
removed.
removed.
a) Assembly of the Filament Holder and the Filament Hose
Assembly of the filament holder
1x hexagon screw M8x120
2x car body washer M8
4x nut M8
Push the hexagon screw from the inside outwards through the
corresponding bore in the left side part and attach it from the
outside with a nut.
Put on car body washer and counter with another nut.
At the end of the hexagon screw, turn on a nut, enclose the car
body washer and counter with another nut.
Note: Printable adapters for different filament rollers can be
downloaded from the product page of the 3D printer online.
Note: Printable adapters for different filament rollers can be
downloaded from the product page of the 3D printer online.
Push filament hose into the feed basic part and fasten it at the
filament hose holder with a small cable tie (99 mm).
Caution: do not contract the table tie too far. The filament hose
must not be crushed.
Caution: do not contract the table tie too far. The filament hose
must not be crushed.
Align the filament hose so that it has enough play for move-
ments of the extruder carriage.
Note:
Filaments from various manufacturers cause a high friction
resistance in the hose. Therefore, please check that the fila-
ment can be moved freely before use. If friction is too high,
the alternative filament holder (see „First Print of an Example
Object from the SD Card“) can be used.
Filaments from various manufacturers cause a high friction
resistance in the hose. Therefore, please check that the fila-
ment can be moved freely before use. If friction is too high,
the alternative filament holder (see „First Print of an Example
Object from the SD Card“) can be used.