Renkforce 3D printer RF1000 Single extruder (value.974113) RF1000 Data Sheet
Product codes
RF1000
59
c) Setup and Transport
When setting up the 3D printer, observe that the mains switch at the low power device combination socket must be
easy to reach so that the device can be switched off quickly and easily in case of malfunction.
Ensure proper ventilation when setting up the device. Do not put the device down on soft supports such as a carpet or
bed, etc. the air circulation also must not be impaired by other objects. This prevents heat dissipation from the product
and may lead to overheating (danger of fire).
bed, etc. the air circulation also must not be impaired by other objects. This prevents heat dissipation from the product
and may lead to overheating (danger of fire).
When setting up the device, make sure that it has a stable footing and place it on a stable underground. Persons may
be injured if the 3D printer drops.
be injured if the 3D printer drops.
When setting up the device, make sure that the connection cables are neither pinched nor damaged by sharp edges.
Always place cables so that no one can trip over them or be caught in them. There is a danger of injury.
Never place the device on any valuable or sensitive furniture surfaces without sufficient protection.
• Put up the 3D printer on a level, stable and non-vibration-sensitive surface.
• If you want to transport the 3D printer, secure the moving parts and the heating bed with adhesive tape or cable ties.
d) Mains Connection and First Activation
The mains socket to which the 3D printer is connected must be close to the device and easily accessible to quickly
separate the device from the mains voltage in case of an error.
separate the device from the mains voltage in case of an error.
Do not let the mains cable come into contact with other cables.
Be careful when handling mains cables and mains connections. Mains voltage may cause potentially fatal electric
shock.
shock.
Make sure that no cables lie around openly. Install cables professionally to prevent accidents.
Before plugging in the mains plug, ensure that the device voltage indicated at the 3D printer corresponds to the availa-
ble mains voltage. Do not connect the device if the indication does not correspond to the available mains voltage.
Incorrect supply voltage may lead to irreparable damage to the device and danger to the user.
ble mains voltage. Do not connect the device if the indication does not correspond to the available mains voltage.
Incorrect supply voltage may lead to irreparable damage to the device and danger to the user.
• Plug the low power device plug of the mains line into the low power device combination socket at the rear of the device.
• Plug the mains plug of the mains line into a protective contact socket.
• Switch on the printer with the mains switch at the low power device combination socket (put the switch in position I).
• The lighting now lights up and the display shows the welcome screen briefly.
Then the main menu appears:
• Plug the mains plug of the mains line into a protective contact socket.
• Switch on the printer with the mains switch at the low power device combination socket (put the switch in position I).
• The lighting now lights up and the display shows the welcome screen briefly.
Then the main menu appears:
(1) Extruder temperature (actual/target)
(2) Temperature heating bed (actual/target)
(3) Print plate offset in mm from the home position
(4) Measured value of the print sensors at the extruder
(5) Status information
(2) Temperature heating bed (actual/target)
(3) Print plate offset in mm from the home position
(4) Measured value of the print sensors at the extruder
(5) Status information
The target temperatures are not displayed here yet, since the extruder and heating bed are not heated yet.