Bunn Single SH DBC* (with Smart Funnel) Owner's Manual

Page 34

5.  The display should read TEST OUTPUTS.

6. In 

TEST OUTPUTS screen, press NO.  This advances 

to TEST SWITCHES.

7. Pressing NO in this screen will advance to the  

next function. Press YES in the TEST SWITCHES 

screen to test the switches.  The display will read 

NOTHING PRESSED.

8.  From this screen, press any of the switches on the 

front of the brewer.  While the switch is pressed, 

the display shows the name of that switch.  If the 

name does not appear, or if it remains after the 

switch has been released, the switch is defective.  

Each switch can be tested in this manner. 

9.  After all switches have been tested, press the ® 

pad located on the front switch panel. This will 

exit  TEST SWITCHES and return to the MAIN 

This function allows the operator to test the op-

eration of the Soft Heat server. It will also show if the 

server is correctly placed on the brewer stand.

1.  Place brew funnel into rails of the brewer.

2.  Place a Soft Heat server beneath the brew fun-

nel.

3.  Press and hold the ® pad until the display reads 

SET NEW RECIPES. Release the ® pad. Continue 

pressing and releasing the ® pad until SERVICE 

TOOLS appears. 

4. Pressing NO  will exit this function and advance to 

the next function screen. Press YES to run tests 

on various components and outputs within the 

brewer.

5.  The display should read TEST OUTPUTS

6. In TEST OUTPUTS screen, press NO. This ad-

vances to TEST SWITCHES. Press and release 

NO once more. The display should now read TEST 

7. Press YES in the TEST SERVER screen to show 

if a server is in place. The display should read IN 

8.  Lift and pull the Soft Heat server forward about 2 

inches so that the two contacts on the server do 

not touch the two contacts on the brewer.

9.  The display should then read SERVER RE-

MOVED.

10.  After the servers has been tested, press and release 

the 

 pad located on the front switch panel. This 

will exit TEST SERVER  and return to the MAIN 

1.  Place brew funnel into rails of the brewer.

2.  Place a Soft Heat server beneath the brew fun-

nel.

3.  Press and hold the ® pad until the display reads 

SET NEW RECIPES. Release the ® pad. Continue 

pressing and releasing the ® pad until SERVICE 

TOOLS appears. 

4. Pressing NO  will exit this function and advance to 

the next function screen. Press YES to run tests 

on various components and outputs within the 

brewer.

5.  The display should read TEST OUTPUTS.

6. In TEST OUTPUTS screen, press NO.  Continue to 

press and release NO until the display reads  TEST 

7.  Press and release YES. The display will show the 

frequency of the sensor coil circuits. This is for 

diagnostic service use when troubleshooting this 

circuit.

8.  After the coils have been tested, press and release 

the 

 pad located on the front switch panel. This 

will exit the TEST FREQUENCY function and return 

to the MAIN SCREEN.

NOTE: If the operator wishes to test more than one 

function in the SERVICE TOOLS section (outputs, 

switches, servers, or coil frequency), it is not 

necessary to exit the program. Use the flow chart 

for  SERVICE TOOLS to navigate to a particular 

function.

34025  022509