Behringer Europack Pro RX1202FX User Manual

EURORACK PRO RX1202FX User Manual

CD/TAPE TO MIX
When the CD/TAPE TO MIX switch is pressed, the CD/tape input is assigned to 

the main mix providing an additional input for tape machines, MIDI instruments 

or other signal sources that do not require any processing.

Fig. 2.5: Effects section

100 FIRST-CLASS EFFECTS
The EURORACK RX1202FX features a built-in digital stereo effects processor. 

This effects processor offers a large number of standard effects such as Hall, 

Chorus, Flanger, Delay and various combination effects. Using the FX control, 

you can feed signals into the effects processor. The integrated effects 

module has the advantage of requiring no wiring. This way, the danger of 

creating ground loops or uneven signal levels is eliminated at the outset, 

completely simplifying the handling.

SIG and CLIP LED
The SIG LED on the effects module shows the presence of a signal whose level 

is high enough. This LED should always be on. However, make sure that the 

CLIP LED lights up only sporadically. If it is lit constantly, you are overdriving 

the effects processor, which leads to unpleasant distortion. If this occurs, 

turn the FX controls down somewhat.

PROGRAM
The PROGRAM control has two functions: by turning the PROGRAM control, 

you dial the number of an effect. The number of the preset you just dialed up 

blinks in the display. To confirm your selection, press the PROGRAM control; 

the blinking stops.

FX TO MAIN
By using the FX TO MAIN controller, the effects signal is sent to the main mix. 

No effects signal is to be heard in the summed signal of the mixer when the 

controller is positioned entirely to the left. Choose this position if you want to 

use an external effects device for the FX output.
An overview of all the multieffect processor’s presets are to be found in 

the appendix.

FUSE HOLDER/IEC MAINS RECEPTACLE
 The mains connection is made via a cable with an IEC mains connector and 

meets the required safety standards. An appropriate mains cable is supplied 

with the equipment. Blown fuses must only be replaced by fuses of the same 

type and rating.

Fig. 2.6: Voltage supply and fuse

POWER switch
Use the POWER switch to turn on the mixing console. The POWER switch 

should always be in the “Off” position when you are about to connect your unit 

to the mains.
To disconnect the unit from the mains, pull out the main cord plug. 

When installing the product, ensure that the plug is easily accessible. 

If mounting in a rack, ensure that the mains can be easily disconnected 

by a plug pull or by an all-pole disconnect switch on or near the rack.

PHANTOM switch
The PHANTOM switch activates the phantom power (necessary to operate 

condenser microphones) on the XLR sockets of the mono channels. 

The red +48 V LED illuminates when phantom power is on. As a rule, 

dynamic microphones can still be used with phantom power, provided that 

they are wired in a balanced configuration. In case of doubt, contact the 

microphone manufacturer!

SERIAL NUMBER
Please note the important information on the serial number given in 

chapter 1.3.3.