Siemens TC63 User Manual

s

TC63_ATC_V00.490

Page 434 of 501

5/24/05

Confidential / Draft - Do not copy

The 

 read command returns the current 

 and current 

. The read command can be

used while test playback is off or on. In the latter case, see execute command for details. 

The 

 execute command is intended for testing. It starts to play a melody from the audio output currently

selected with 

. To deactivate test playback use 

 again.

During test playback, you can enter the write command to select another melody and adjust the volume. Also,

you can enter the read command to check the type and volume of the current ring tone, and to view the status

of playback (on / off). The test ringing signal cannot be activated when an MTC is ringing (ERROR).

Selecting 

=0 during the test, immediately stops playback. After this, ring tones will be muted until you

change 

 using the write command. 

The 

 write command chooses the type and volume of ring tones. The settings can be changed no matter

whether or not the ME is ringing. The selected type and volume are saved in the non-volatile Flash memory and,

thus, are retained after Power Down. An exception is 

=0, that can be entered to quickly mute the tone or

melody currently played to indicate an event. 

=0 only stops immediately the audible ring tone, but does

not terminate the URC that indicates the event (for example RING). No permanent settings are changed or

saved. 

Test Command

AT^SRTC=?

Response(s)

^SRTC:

(list of supported) 

s, (list of supported) 

OK

Read Command

AT^SRTC?

Response(s)

OK

Exec Command

AT^SRTC

Response(s)

OK

Write Command

AT^SRTC=

[

][, 

]

Response(s)

OK

ERROR

Reference(s)

PIN

ASC0 ASC1 USB MUX1 MUX2 MUX3 Charge

4

Last

SIEMENS

!

%

%

%

%

%

%

!

%

!