SBE HighWire HW400c/2 User Manual
HighWire HW400c/2 User Reference Guide Rev 1.0
3.4.1 Switch Re
3.4.2 MV64462 S s
the HW400c/2 can be accessed via the
000 Mbps and is a
rced from the Ethernet switch. The
the receiver signals on the
stem controller, and vice-versa for a direct MAC-to-MAC connection.
3.4.3 Front Panel (RJ-45) Ethernet Interface
he HW400c/2 board
lded RJ-45 (with integrated transformer
nd two
s) located at the front panel that provides an Ethernet LAN
terface. The port is auto-negotiating and auto-sensing, and operates at 10/100/1000
bps. The left LED (looking at the port) indicates Link/Activity/Speed and the right
ED indicates collision detection (See Figure 12).
The Link
solid green when the network link is up;
Hz for 10 Mb/s Tx or Rx;
• blinking at 6 Hz for 100 Mb/s Tx or Rx;
gisters Initialization and Monitoring
The switch is initialized and its registers polled by utilizing its SPI bus interface.
This interface is connected through the CPLD. For a description of how to access the
SPI interface, please refer to Section 4.4.
This interface is connected through the CPLD. For a description of how to access the
SPI interface, please refer to Section 4.4.
y tem Controller Ethernet Interface
The Marvell MV64462 System Controller on
BCM5388 Ethernet switch. The connection speed must be set to 1
MAC-to-MAC connection with the clock sou
transmitter signals from the switch are connected to
sy
BCM5388 Ethernet switch. The connection speed must be set to 1
MAC-to-MAC connection with the clock sou
transmitter signals from the switch are connected to
sy
T
includes a fully shie
a
in
in
green LED
M
L
L
/Activity/Speed LED indication is as follows:
•
• blinking at 3
• blinking at 3
• and blinking at 12 Hz for 1000 Mb/s Tx or Rx.
Ethernet
Link/activit speed Collision
y/
Figure 12. Front panel Ethernet RJ-45 LEDs
October 10, 2006
Copyright 2006, SBE, Inc.
Page
28