Toshiba Magnia Z300 User Manual

206

See the operating manual of the display unit.

6 When running Windows NT/2000, boot up in the VGA mode, 

and make sure that the settings (resolution, synchronizing fre-
quency) are as supported by the display unit.

Probable causes are faulty connection of the display signal cable 
or power cable, or a problem with the brightness or contrast set-
tings. Carry out the following procedure to check the cause of the 
trouble. If this does not remedy the problem, see “Remedy When 
Windows NT/2000 is Unusable” on page 213.

1 Is the display unit properly connected to the server?

If the switch box is used on a Rack Type, also check the con-
nections with other devices and that the server is properly 
selected.

2 Switch on the display unit, and set the brightness and contrast 

to two thirds of the maximum value or more.

See the operating manual of the display unit.

3 When running Windows NT/2000, boot up in the VGA mode, 

and make sure that the settings (resolution, synchronizing fre-
quency) are as supported by the display unit.

When the lit state of the system status indicators and disk status 
indicators differs from the specifications described in this manual, 
a probable cause is malfunction of the indicator, faulty cable con-
nection, or other internal trouble on the server. If Windows NT/
2000 can be used, see “Remedy When Windows NT/2000 is 
Usable” on page 212.

If Windows NT/2000 cannot be used, see “Remedy When Win-
dows NT/2000 is Unusable” on page 213.