Hampton Bay H200 User Manual
Hampton H200 Cast Freestanding Woodstove
19
CAUTION: Label all wires
prior to disconnection
when servicing controls.
Wiring errors can cause
improper and dangerous
operation.
prior to disconnection
when servicing controls.
Wiring errors can cause
improper and dangerous
operation.
WARNING: Electrical Grounding
Instructions
This appliance is equipped with
a three pronged (grounding) plug
for your protection against shock
hazard and should be plugged
directly into a properly grounded
three-prong receptacle. Do not cut
or remove the grounding prong
from this plug.
a three pronged (grounding) plug
for your protection against shock
hazard and should be plugged
directly into a properly grounded
three-prong receptacle. Do not cut
or remove the grounding prong
from this plug.
An optional blower is available for the Hampton
H200. The blower is factory assembled, wired
and ready for attachment to the stove.
H200. The blower is factory assembled, wired
and ready for attachment to the stove.
This unit must be connected to a grounded,
standard 120 volts, 60 Hz electrical outlet.
Never route the power cord under or in front
of the unit.
standard 120 volts, 60 Hz electrical outlet.
Never route the power cord under or in front
of the unit.
Do not under any circumstances, cut or remove
the grounding prong from the power cord. Do
not use an adaptor plug.
the grounding prong from the power cord. Do
not use an adaptor plug.
CAUTION: Moving parts may cause injury.
Do not operate unit with blower housing
removed.
Do not operate unit with blower housing
removed.
DANGER: Risk of electric shock. Discon-
nect power before servicing unit.
nect power before servicing unit.
NOTE: For more detailed information see
instructions included with the Optional
Blower.
instructions included with the Optional
Blower.
OPTIONAL BLOWER/FAN INSTALLATION
Ground
Fan
Fan
Ground
Green
Neutral
Live
White
Fan
Switch
Manual/
Auto
Switch
Black
Black
High
(Black)
Low
(Red)
Black
Fan Thermodisc
(normally open)
120V AC
60 Hz
Blower/Fan Wiring Diagram
NOTE INPUT POWER: Australia, New Zealand,
China and Japan use 240V AC 50 Hz.
China and Japan use 240V AC 50 Hz.
INSTALLATION
1) Remove fan cover plate from back shield
by undoing 3 screws and discard plate.
2) Remove back shield by undoing 2 bolts.
3) Loosen the 2 bolts you see after remov-
ing back shield, one on each side of the
stove.
stove.
4) Hook fan over the bolts.
Fan
5) Tighten bolts to secure fan.
Tighten
bolts
6) Re-install back shield.
Back
Shield
7) Using the 3 screws from the fan cover
plate, secure the fan assembly to the back
shield.
shield.
8) Plug in power cord.