Hampton Direct H200 User Manual

Hampton H200 Cast Freestanding Woodstove

6

After removing the stove from its packing, open 
the front door and remove the contents from the 
fi rebox, leaving the bricks in place.

This stove can be connected to either a top or 
rear vent exit by simply reversing the orientation 
of the elbow.

Simply remove the 2 screws, change the position 
of the elbow as desired and secure in place  
with screws.

(Used only on Vertical Installations)

1)  Loosen the bolts that secure the elbow to 

the unit. Ensure elbow does not fall off.

2)  Bend the tabs on the rear heat shield inwards 

90 degrees.

3)  Slide the tabs on the rear heat shield in 

between the bolt and washer.

4)  Once rear heat shield is evenly in place, 

tighten bolts to secure.

Please Note: The shield needs to be stretched/
fl exed in order to fi t in place.

1)  Insert bolt and lock washer through draft 

control lever hole.

2)  Place handle through bolt. Tighten to se-

cure.