Hampton Direct H300 User Manual

Hampton H300 Cast Freestanding Woodstove

6

After removing the stove from its packing, open 
the front door and remove the contents from the 
fi rebox, leaving the bricks in place.

This stove can be connected to either a top or 
rear vent exit by simply reversing the orientation 
of the elbow.

Simply remove the 2 screws, change the posi-
tion of the elbow as desired and secure in place  
with screws.

1)  To install side door handle, remove side 

door plug assembly. 

1)  Loosen the bolts that secure the elbow to 

the unit. Ensure elbow does not fall off.

2)  Bend the tabs on the rear heat shield inwards 

90 degrees.

2)  Assemble handle by:
 

a) Placing lock washer over hex head bolt.

 

b) Place hex head bolt into handle.

 

c) Place spacer over hex head bolt 
    threads.

 

d) Screw handle into side door latch.

3)  Slide the tabs on the rear heat shield in 

between the bolt and washer.

4)  Once rear heat shield is evenly in place, 

tighten bolts to secure.

Please Note: The shield needs to be stretched/
fl exed in order to fi t in place.

3)   Place side door handle latch through side 

door hole.

4)   Re-assemble side door plug assembly to 

secure.

1)  Insert bolt and lock washer through draft 

control lever hole.

2)  Place handle through bolt. Tighten to se-

cure.