Fortec Satellite TV System Innovation User Manual

 

22 

 
9.1 Welcome to Fortec Star HD World 

y

  The very first time you turn your receiver on, or after a 

Factory Reset, the language selection menu appears on 
your TV screen. 

y

 Use 

the 

e/f/▲/▼   buttons to select the language. 

y

  Press OK button to go to next step. 

 

 
 

y

  Select the satellite by pressing e/f buttons and choose 

from the list. 

y

  Select your LNB type using thee/f buttons. 

y

  Select the correct DiSEqC setting for your antenna. If 

you have a single antenna, chose OFF. Otherwise, 
chose the corresponding DiSEqC output.  

y

  Select DiSEqC 1.1 setting if you are using 4 or more 

LNB’s. 

y

  Choose an active TP for the selected satellite (You will 

only get a signal from an active TP.  If in doubt, please 
check www.lyngsat.com or www.satcodx.com for a TP 
that is broadcasting a channel.  These Web sites provide a full list of all satellites and the 
channels available on each satellite.) 

y

  Use Power ON if the receiver is going to feed the LNB. (This is typically the case.) 

y

  Select DiSEqC 1.2 or USALS if you are going to use a motor. If so, after selecting it press OK in 

order to set up the motor parameters.  

y

  If the setting is completed, your antenna is set up properly and pointed correctly to the selected 

satellite the two bars will show the level and quality of the signal. 

y

  Save the current setting using the Red button on the remote control.