Dynojet Research Microphone 200iP User Manual

     

. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Refer to “Replacing Pit Cover Plates and Upright Brace—200iP/250iP” on page 34 for 
model 200iP/250iP dynos.
1

Secure the center panel to the dyno carriage using the six 1/4-inch screws 
removed earlier. Refer to Figure 4 on page 6.

2

Secure the three carriage clamps and shims using two 5/16-inch bolts and washers 
each. Refer to Figure 4 on page 6.

3

Secure the nut block and shim using two 5/16-inch bolts and washers. Refer to 
Figure 4 on page 6.

4

Replace the tire carriage by sliding it under the carriage clamps. Refer to Figure 3 
on page 5.

5

Slide the carriage screw and the bearing bracket toward the nut block until the 
carriage screw is touching the nut block. Refer to Figure 3 on page 5.

6

Secure the bearing bracket to the carriage using four 1/4-20 x 5/8-inch pan head 
screws. Refer to Figure 3 on page 5.

7

Using the hand crank, screw the carriage through the nut block and into the 
screw support bracket. Refer to Figure 3 on page 5.

8

Secure the right side drum cover to the dyno frame using the six 1/4-20 x 5/8-inch 
pan head

 

screws removed earlier. Refer to Figure 2 on page 4.

9

Secure the top of the right side drum cover to the dyno using the two 
1/4-20 x 5/8-inch pan head screws removed earlier. Refer to Figure 2 on page 4. 

10 Secure the drum module hood to the dyno using the eight 1/4-20 x 5/8-inch pan 

head screws removed earlier. Refer to Figure 1 on page 3.