Datalogic Scanning Controller SC6000 User Manual
SC6000
4
In case of SC6000 failure proceed as follows:
Figure 33 - Removing the Compact Flash
1. Disconnect the device
2. Remove the rubber cover of the Compact Flash slot using a screwdriver
3. Remove the Compact Flash
4. Connect a new SC6000 to the system
5. Insert the Compact Flash card
CAUTION
Make sure not to insert the Compact Flash card upside down. Carefully
insert it in the guides, so that it will not fall inside the device. Gently push it
into the slot.
insert it in the guides, so that it will not fall inside the device. Gently push it
into the slot.
6. Start up the system
The system configuration is automatically restored and the reading station is ready to start
working again.
The system configuration is automatically restored and the reading station is ready to start
working again.
32