Bunn Juicer JDF-4S User Manual

7

FIG  5  Initial Fill Connection - JDF-2S

P3582

7.  Turn ON the refrigeration switch near the main control board. This will start the water bath pump circulation.

8.  Check water level in the overflow tube and top off the tank if necessary (Step 5).

9.  Disconnect the fill tube and allow excess water to drain into the drip tray. Replace the plug in the end of the 

fill tube and store back into the dispenser.

10. Set the Program Switch (near main control board) to the OFF position. (On older models without program 

switch, set the Dispense Lockout Switch to the ON position)

11. Replace the splash panel and drip tray.

12. It will take several hours to create the ice bank required for full dispenser performance. During this time, some 

further trickling from the water bath is expected due to expansion caused by ice bank formation. While the 

refrigeration system is creating the ice bank, the dispenser may be readied for use as described in Loading, 
Priming and Adjustment.

FIG  6  Initial Fill Connection - JDF-4S

P3842

1.  Thaw the frozen concentrate in a refrigerated 35-40 degrees F (1.6-4.4 degrees C) environment for 36 to 48 

hours before use.

2.  Thoroughly mix the thawed concentrate by vigorously shaking the product container.

3.  Open the dispenser door.

4.  Prior to placing the product container in the dispenser, make sure that the o-ring on the container adapter is 

lubricated. This will ease removal of the container when it becomes necessary.

5.  Place the product container in the desired position and press it firmly into the bottle adapter opening.

6.  Open the vent hole in the product container.

Note: Concentrate in the container must be completely thawed and be within the temperature range of 35-40 

degrees F (1.6-4.4 degrees C.) Product outside of this temperature range, especially below, will produce an “out 

of brix” drink.

1.  Install an Ambient Concentrate Conversion Kit (BUNN-O-MATIC part number 33699.0002) per the instruc-

tions provided in the kit.

2.  Attach the concentrate product hose to the appropriate concentrate line located at the rear of the dispenser.

3.  Attach the other end of the product hose to the product container through an appropriate fitting.

44744 032811