Whirlpool W10038100 User Manual

Page of 8
7
NOTE: Do not overtighten or use tape or sealants on the 
valve. Damage to the valves can result. 
5. Attach the cold water hose to the top inlet valve. 
6. Screw on coupling by hand until it is seated on the washer. 
7. Using pliers, tighten the couplings with an additional 
two-thirds turn. 
NOTE: Do not overtighten or use tape or sealants on the 
valve. Damage to the valves can result.
Check for leaks
Turn on the water faucets and check for leaks. A small amount of 
water might enter the washer. You will drain this later.
NOTE: Replace inlet hoses after 5 years of use to reduce the risk 
of hose failure. Record hose installation or replacement dates for 
future reference.
If you connect only one water hose, you must cap off the 
remaining water inlet port.
Periodically inspect and replace hoses if bulges, kinks, cuts, 
wear, or leaks are found.
Secure the Drain Hose
1. Remove the shipping strap from the power cord. Drape the 
power cord over the console.
2. Remove any cardboard used to move washer.
3. Wrap the drain hose to the laundry tub leg or drain standpipe 
with the beaded tie strap. Push fastener into the nearest hole 
in the beaded tie strap. See view A or B.
If the washer faucets and the drain standpipe are recessed, 
put the formed end of the drain hose into the standpipe. 
Tightly wrap the tie strap around the water inlet hoses and the 
drain hose. See view C.
Level the Washer
Properly leveling your washer avoids excessive noise and 
vibration.
Install the Front Leveling Feet
1. Prop up the front of the washer about 10.2 cm (4") with a 
wood block or similar object. The block needs to support the 
weight of the washer.  
2. Screw the locknut onto each foot to within 2.5 cm (1") of the 
foot base. 
3. Screw the feet into the threaded holes at the front corner of 
the washer until the nuts touch the washer. Twist the feet to 
install.
NOTE: Do not tighten the nuts until the washer is level. 
4. Tilt the washer back and remove the wood block. Gently lower 
the washer to the floor.
Steps in Final Location
1. Slide the washer to its final location.
Beaded tie strap
C
B
A
A. Threaded holes for feet
A
10.2 cm
(4")
2.5 cm
(1")