Siemens Camera Accessories 6DS2-510-0xx00-0xa0 User Manual

Product Information

February, 1999

BRIDGE CS-L2

S79220-A0978-A-05-7637

Page 4 of 20

2.2 Procedure for Upgrade to V02.01 with Programming Device PG740

Switch off the power supply of the BRIDGE CS-L2 before pulling the memory card!

For the upgrade, insert the memory card into the MEM-CARD slot of the PG740. Now start
the batch UPGRADE.BAT (if applicable, information on the memory card drive, default
setting is E:):
This batch file

creates a directory C:\UPGRADE.201 (for this, at least 1 MByte must be free on drive
C:).

copies all files from memory card into the upgrade directory.

deletes the RMOS system file, as this can never be copied to the MC.

deletes all BAK files.

copies the packed upgrade files from disk into the directory (the system files to be
upgraded are then overwritten).

reformats the memory card and sets up the RMOS system.

copies all files from the upgrade directory to the memory card

Now perform the following two steps:
1) Put the upgraded memory card in the allocated Bridge CS-L2 and initiate a reboot of

the CPU (power on).

2) Install the new terminal program ASBEDIEN V1.06 to your PC from the diskette

included with your delivery (IBS tools).

Notes:

The upgrade batch runs under Windows 95 and 3.1, but not under Windows NT !

Subdirectories on the Memory Card will not be copied. These have to be saved to the PC/
Programming device bevor starting the upgrade procedure.

The upgrade directory is not deleted. This means that, if an error should occur during the
upgrade process, the process can be repeated.
Attention: If more than one Bridge memory card are upgraded the directory

UPGRADE.201 must either be deleted or renamed between the individual
upgrade processes.

The upgrade directory can also be used as a backup copy of the entire system software.
This means that repairs can be carried out on memory cards with defective software
(create directory UPGRADE.200, copy backed up file to it and start the batch file).