Whirlpool GXW733xDXS Installation Instruction

IMPORTANT: Clean the hood and grease filters frequently 
according to the following instructions. Replace grease filters 
before operating hood.

IMPORTANT: Do not use soap-filled scouring pads, abrasive 
cleaners, Cooktop Polishing Creme, steel wool, gritty washcloths 
or paper towels.

To avoid damage to the stainless steel, do not use cleaners that 
contain chlorine.

■

Rub in direction of grain to avoid scratching or damaging the 
surface.

■

Stainless Steel Cleaner and Polish Part Number 31462A (not 
included): 
See “Assistance or Service” section to order.

■

Liquid detergent or all-purpose cleaner:
Rinse with clean water and dry with soft, lint-free cloth.

■

Glass cleaner to remove fingerprints.

1. Remove each filter by pulling the spring release handle and 

then pulling down the filter. 

2. Wash metal filters as needed in dishwasher or hot detergent 

solution.

3. Reinstall the filter by making sure the spring release handles 

are toward the front. Insert aluminum filter into upper track.

4. Push in spring release handle.

5. Push up on metal filter and release handle to latch into place.

6. Repeat steps 1-5 for the other filter.

Turn off the range hood and allow the fluorescent lamp to cool. 

1. Disconnect power.

2. Remove the screw from the lens cover and remove the cover.

3. Remove the light from the socket and replace with a 120-volt, 

13-watt (maximum), 50° fluorescent light with a GX24 base.

4. Replace the lens cover and screw. Tighten the screw.

5. Reconnect power.

If new light does not operate, make sure the lamp is inserted 
correctly before calling service.

A

A

B

C