Whirlpool GXW65DXS Installation Instruction
9
Make Electrical Connection
1. Disconnect power.
2. Remove terminal box cover.
3. Remove the knockout in the terminal box cover and install a
UL listed or CSA approved
¹⁄₂" strain relief.
4. Run home power supply cable through strain relief, into
terminal box.
5. Use UL listed wire connectors and connect black wires (C)
together.
6. Use UL listed wire connectors and connect white wires (E)
together.
7. Connect green (or bare) ground wire from home power supply
to yellow-green ground wire (E) in terminal box using UL listed
wire connectors.
wire connectors.
8. Tighten strain relief screw.
9. Install terminal box cover.
10. Check that all light bulbs are secure in their sockets.
11. Reconnect power.
Install Vent Covers
When using both upper and lower vent covers, push lower cover
down onto hood and lift upper cover to ceiling and install with
two 4 x 8 mm screws.
down onto hood and lift upper cover to ceiling and install with
two 4 x 8 mm screws.
NOTE: For vented installations the upper vent cover may be
reversed to hide slots.
reversed to hide slots.
A. Knockout
B. Terminal box cover
B. Terminal box cover
A. Home power supply cable
B. UL listed or CSA approved strain relief
B. UL listed or CSA approved strain relief
C. Black wires
D. UL listed wire connectors
D. UL listed wire connectors
E. White wires
F. Green (or bare) and yellow-green ground wires
F. Green (or bare) and yellow-green ground wires
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
A
B
A
B
C
D
E
F
A. Bracket
B. 4 x 8 mm screws
B. 4 x 8 mm screws
C. Vent cover
WARNING
Electrical Shock Hazard
Electrically ground blower.
Connect ground wire to green and yellow ground wire
in terminal box.
in terminal box.
Failure to do so can result in death or electrical shock.
C
A
B