Vinotemp VT34TS Owner's Manual

7 

1 7 6 2 1   S o u t h   S u s a n a   R o a d ,   R a n c h o   D o m i n g u e z ,   C a l i f o r n i a   9 0 2 2 1  

i n f o @ v i n o t e m p . c o m  

 

 

 
For your protection, this unit should be properly 
grounded. Unit is equipped with a 3-conductor 
cord set that has a molded 3-prong grounding-
type plug, and should be used in combination 
with a properly connected grounding-type outlet 
as shown in figure A.  
 
It is not recommended to use this wine cellar 
with an extension cord or power board. Please ensure that the appliance 
is plugged directly into the electrical outlet. 

•  Remove the exterior and interior packaging before use. 

•  Check to be sure you have all of the parts and an owner’s manual. 

•  Place your wine cellar on a flat, dry surface that is strong enough to 

support the unit when fully loaded. 

•  This unit is designed for free standing installation only.  

•  Do not place heavy objects on top of the unit. 

•  Unit is not designed for installation in a garage, basement, or any 

other location where a controlled ambient environment between 60° 
and 90°F cannot be maintained. 

•  Do not place the unit in direct sunlight or near sources of heat. 

Extreme hot and cold ambient temperatures may cause the unit not 
to perform properly or increase electrical consumption. 

•  Do not place the unit next to a major appliance that emits large 

amounts of heat, such as a dishwasher, microwave, oven, etc. 

•  Do not plug unit into the same outlet as a refrigerator or microwave. 

•  Before connecting the appliance to the power source, let it stand 

upright for approximately 24 hours. This will reduce the possibility 
of a malfunction in the cooling system from handling during 
transportation. 

•  Clean the interior surface with lukewarm water using a soft cloth 

before first use. 

•  The unit is designed for freestanding installation only. It is not 

designed to be installed under a counter, inside a cabinet, or in any 
location that does not allow the proper clearances on all sides.  

•  IMPORTANT: To function correctly, wine cooler needs a minimum 

of 10-12 inches clearance on each side and 6 inches clearance at 
the rear.