GE GTV21GSSJWW Specification Sheet

For answers to your Monogram,

® 

GE Profile

™

 or  

GE

®

 appliance questions, visit our website at 

geappliances.com or call GE Answer Center

®

 

service, 800.626.2000.

GTV21GSSJ 

GE

® 

7.0 cu. ft. capacity Dura Drum gas dryer with 150 ft. long venting

Exhaust Options: 

2-way via rear and bottom. Dryer is shipped exhausted to the rear. Alternate 

exhausting knockouts are supplied. 
Gas: An individual properly-grounded branch circuit, with a three-prong grounding-

type receptacle, protected by a 15 or 20 amp circuit breaker or a time-delay fuse  

is required.
Gas Dryer Electric Rating: 120V, 60Hz, 6A
Gas (BTU/HR): 22,000. Factory-equipped for natural gas. Tested for LP gas. LP gas 

supply requires a conversion kit. Check installation instructions for correct kit and 

have a qualified gas technician install a conversion kit. See dryer ducting information 

for proper installation.
Note: Dryer wall outlet must be located within 36" of service cord entry and 

accessible when dryer is mounted in position.
Installation Information: For complete information, see installation instructions 

packed with your dryer.

Special Installation Requirements
Alcove or Closet Installation: 

•  If your dryer is approved for installation in an alcove or closet, it will be stated on a label 

on the dryer back.

• The dryer MUST be exhausted to the outside. 

•  Minimum clearances between dryer cabinet and adjacent walls or other surfaces 

are:

 

0" either side 

 

3" front and rear

• Minimum vertical space from floor to overhead cabinets, ceilings, etc. is 52". 

•  Closet doors must be louvered or otherwise ventilated and must contain a minimum 

of 60 sq. in. of open area equally distributed. If this closet contains both a washer and 

a dryer, doors must contain a minimum of 120 sq. in. of open area equally distributed.

• No other fuel-burning appliance shall be installed in the same closet with a gas dryer.
Bathroom or Bedroom Installation:

• The dryer MUST be exhausted to the outdoors. 

•  The installation must conform with the local codes, or in the absence of local codes, 

with the National Electric Code and National Fuel Gas Code, ANSI Z223 for gas dryers.

•  Minimum clearances to combustible surfaces 

  0" both sides 

  3" rear