Whirlpool WUW35X15DS Owner's Manual

■

Remove tape and glue residue from surfaces before turning 
on the wine cellar. Rub a small amount of liquid dish soap 
over the adhesive with your fingers. Wipe with warm water 
and dry.

■

Do not use sharp instruments, rubbing alcohol, flammable 
fluids, or abrasive cleaners to remove tape or glue. These 
products can damage the surface of your wine cellar. For 
more information, see “Wine Cellar Safety.”

■

Dispose of/recycle all packaging materials.

After you remove all of the packaging materials, clean the inside 
of your wine cellar before using it. See the cleaning instructions in 
“Wine Cellar Care.”

Your wine cellar has four leveling legs. If your wine cellar seems 
unsteady or you want the door to close more easily, adjust the 
wine cellar’s tilt using the instructions below.

1. Plug into a grounded 3 prong outlet.

2. Move the wine cellar into its final location. 

3. Turn the leveling legs to the right to lower the wine cellar or 

turn the leveling legs to the left to raise it. It may take several 
turns of the leveling legs to adjust the tilt of the wine cellar. 

NOTE: Having someone push against the top of the wine 
cellar takes some weight off the leveling legs. This makes it 
easier to adjust the leveling legs.

4. Open the door and check that it closes as easily as you like. If 

not, tilt the wine cellar slightly more to the rear by turning both 
front leveling screws to the left. It may take several more 
turns, and you should turn both leveling legs the same 
amount.

Your wine cellar is heavy. When moving the wine cellar for 
cleaning or service, be sure to cover the floor with 
cardboard or hardboard to avoid floor damage. Always pull 
the wine cellar straight out when moving it. Do not wiggle 
or “walk” the wine cellar when trying to move it, as floor 
damage could occur.