Marvel ML24BNS1RB Owner's Manual

11

Figure 12 Electronic single zone 

control

Plug the appliance power cord into a 115 volt wall outlet. 

Your appliance is shipped from the factory in the "On" posi-

tion and will begin start-up of cooling as soon as power is 

supplied. If the appliance does not start, confirm that the 

wall outlet has power, and that the control is in the "On" 

position, (See "Turning your appliance On and Off" below). 

The control display is covered with a clear plastic film. This 

film may be removed by carefully lifting the film at a corner.

On initial power up, the control display will indicate a 

"Power Failure" alarm. This is a normal condition as the ap-

pliance was powered-up at the factory for quality inspection 

and then removed from power. A momentary press of the 

"On/Off" keypad will reset this alarm condition. (See Alarms 

section on page 12).

To wake the display press any keypad. A confirm tone will 

sound, and the current storage compartment temperature 

will be displayed. 

If no keypads are pressed for 60 seconds, the display will 

enter sleep mode to conserve power. The control panel will 

go dark with the exception of the system status "OK" indi-

cator which will remain enabled. Alarm conditions will wake 

the display, (see alarms on page 12).

The sleep mode can be disabled if you prefer to have the 

display on continuously. Press and hold the "Lock" key-

pad until the display goes past "Loc" and reads "nSL". To 

enable the sleep mode, repeat the instruction, again going 

past "Loc" until the display reads "SLP".

If the appliance is "On", (and out of sleep mode) the tem-

perature will be shown in the display area of the control. 

To turn the appliance "Off", press and hold the "On/Off" 

keypad for 4-seconds. "OFF" will now be displayed on the 

control.

To turn the appliance "On", press and hold the "On/Off" 

keypad for 4-seconds.