Marvel ML24BNS1RB Owner's Manual

12

The temperature mode is preset from the factory in Fahren-

heit (°F) but you have the option to change it to Centigrade 

(°C). To change the mode, press and hold the "-" keypad, 

while pressing the "+" keypad, then release the "-" keypad.

The temperature will now be displayed in Centigrade (°C).

Repeat the procedure to change the temperature mode 

back to Fahrenheit (°F).

The control panel can be locked to avoid unintentional 

changes. To lock the control, press and hold the "Lock" key-

pad until the display reads "Loc" then release your finger 

from the keypad. The lock icon will flash 3-times and then 

continuously illuminate. When the control panel is locked, 

only the Lock keypad, System Status OK indicator , and 

the Alarm indicator are active. To un-lock the control panel, 

repeat this instruction until the display reads "nLc".

The control will alert you to conditions that could adversely 

affect the performance of the appliance.

•  Door ajar - 

If the door is open, or not closed prop-

erly, for more than 5-minutes the System Status OK 

indicator will turn-off, the "Door Ajar" indicator will flash, 

and a tone will sound every 60 seconds. Additionally, 

an "ALARM RESET" indicator will be displayed below 

the "On/Off" keypad. This alarm condition can be reset 

by closing the door or momentarily pressing the "On/

Off" keypad, (i.e.-if you are cleaning the storage com-

partment, etc.). The alarm will recur in 5-minutes if the 

alarm condition persists.

To set or check the set-point temperature (with the control 

out of sleep mode), press the "-" or "+" keypads. "SET" will 

be indicated on the user interface panel and the current 

set-point temperature will display and flash. Subsequent 

presses of the "-" or "+" keypads will adjust the temperature 

colder or warmer respectively. When you have reached 

your desired set-point temperature, press the "On/Off" key-

pad to accept, or do nothing and the "Set" mode will time-

out in 10-seconds accepting the displayed temperature as 

the new set-point.

The available set-point temperature range for your ap-

pliance is 34°F (1.2°C) to 46°F (7.9°C). If you attempt to 

adjust the temperature outside of this range you will receive 

an audible notification.

If you are using the appliance as a refrigerator for perish-

able foods, the set-point temperature should be set be-

tween 34°F and 42° F (1.2° C and 5.7° C).

When initially loading your product with warm contents, it 

may take up to 48-hours for the storage compartment tem-

perature to stabilize.

When making temperature set-point changes, it may take 

up to 24-hours for the stored contents to stabilize at your 

new set-point temperature.

Factors that affect the storage compartment stabilized 

temperature:

•  Changes to temperature setting.

•  Room temperature changes.

•  Temperature of stored contents.

          - Loading warm contents.

          - Cold content load will delay the change to a warmer

            set-point temperature.

          - Warm content load will delay the change to a colder

            set-point temperature. 

•  Usage, (number and duration of the door openings).

•  Installation of the appliance in direct sunlight or next to 

a heat source.