Marvel ML24BNS1RB Owner's Manual

4

Figure 2

Front Leveling

        Legs

Front Grille, 

keep this area 

open.

Adjustable legs at the front and rear corners of the appli-

ance should be set so the unit is firmly positioned on the 

floor and level from side to side and front to back. The over-

all height of your Marvel appliance may be adjusted higher 

(by turning the leveling leg out, CCW) and lower (by turning 

the leveling leg in, CW) dimensions as shown in Table "A".

To adjust the leveling legs, place the appliance on a solid 

surface and protect the floor beneath the legs to avoid 

scratching the floor. With the assistance of another person, 

lean the appliance back to access the front leveling legs. 

Raise or lower the legs to the required dimension by turning 

the legs. Repeat this process for the rear by tilting the appli-

ance forward using caution. On a level surface check the 

appliance for levelness and adjust accordingly.

The front grille screws may be loosened and the grille ad-

justed to the desired height. When adjustment is complete 

tighten the two front grille screws. (See Figure 3).

Rear 

Leveling 

Legs

The proper location will ensure peak performance of your 

appliance. We recommend a location where the unit will 

be out of direct sunlight and away from heat sources. To 

ensure your product performs to specifications, the recom-

mended installation location temperature range is from 55 

to 100°F (13 to 38°C).

Ventilation is required from the bottom front of the appli-

ance. Keep this area open and clear of any obstructions.  

Adjacent cabinets and counter top can be installed around 

the appliance as long as the front grille remains unob-

structed. Overlay door models with articulated hinges are 

intended for built-in applications only.

Do not obstruct the front grille. The openings within the 

front grille allow air to flow through the condenser heat ex-

changer. Restrictions to this air flow will result in increased 

energy usage and loss of cooling capacity. For this reason 

it is important this area not be obstructed and the grille 

openings kept clean. AGA MARVEL does not recommend 

the use of a custom made grille as air flow may be restrict-

ed. (See Figure 2).

ML24BNS

ML24BSS

ML24BTS

33 

3

⁄

4

" (85.7 cm)

34 

3

⁄

4

" (88.3 cm)

ML24BNP

ML24BSP

ML24BTP

34" (86.4 cm)

35" (88.9 cm)

Table A