Marvel ML24BNS1RB Owner's Manual

6

Figure 5

Bottom View of

Beer dispenser 

Anti-Tip

Bracket

Leveling Leg

Front of cabinet

21

1

⁄

2

"

(54.6 cm)

If your beer dispenser is not located under a counter top 

(free standing), you must use an anti-tip device installed 

as per these instructions. If the beer dispenser is removed 

from  its location for any reason, make sure that the device 

is properly engaged when you push the beer dispenser 

back into the original location. If the device is not properly 

engaged, there is a risk of the beer dispenser tipping over, 

with the potential for property damage or personal injury. 

If installing on a concrete floor, concrete fasteners are 

required, (not included with the anti-tip kit).

Any finished flooring should be protected with appropriate 

material to avoid damage when moving the unit.

1) Decide where you want to place the beer dispenser. 

Slide it into place, being careful not to damage the floor, 

leaving 1" (2.5 cm) of clearance from the rear wall to allow 

room for the anti-tip bracket.

 

2) Raise the rear leveling legs approximately 

1

⁄

4

" (6 mm) to 

allow engagement with the anti-tip bracket. Level the unit 

by adjusting all the leveling legs as required. Turning the 

leveling leg counterclockwise will raise the unit and clock-

wise will lower the unit.

3) Make sure the beer dispenser is in the desired loca-

tion, then mark on the floor the rear and side corner of the 

cabinet where the anti-tip bracket will be installed. If the 

installation does not allow marking the rear corner of the 

cabinet, then make temporary lines on the floor marking 

the front corner of the cabinet, excluding the door. Slide 

the beer dispenser out of the way. From the temporary line 

extend the sidewall line back 21

1

⁄

2

" (54.6 cm) as shown in 

Figure 6. 

4) Align the anti-tip bracket to the marks on the floor so 

the side of the bracket lines up with the side of the cabinet 

mark, and the "V" notches on the anti-tip bracket line up 

with the end of the 21

1

⁄

2

" (54.6 cm) line (Rear of cabinet 

line).

5) Fasten the anti-tip bracket to the floor using the supplied 

screw. (See Figure 6).

6) Slide the cabinet back into position, making sure the 

rear cabinet leveling leg slides under the anti-tip bracket 

engaging the slot.

The anti-tip bracket is to be located on the floor in the left or 

right rear corner of the beer dispenser as shown in 

Figure 5.

•  ALL APPLIANCES CAN TIP 

RESULTING IN INJURY.

•  INSTALL THE ANTI-TIP 

BRACKET PACKED WITH 

THE APPLIANCE.

•  FOLLOW THE INSTRUC-

TIONS BELOW