GE CVM1750SHSS Installation Instruction

Snip all 4 webs  

on each knockout 

panel and remove  

the metal knockouts 

for rear airflow.

    Locate the two “knockout” plates, on the rear oven 

panel, near the top of the oven. 

    Using tin snips, carefully cut the web area from the 

two holes side-by-side (that secure the knockouts to 

the oven). Cut all four webs on both rear knockouts; 

this will allow the ventilation fan airflow to exhaust 

out the rear of the oven.

   

    Place the blower unit back into the opening.  

    Insert the tabs on each side of the damper  

into the holes at the inside rear of the adaptor.

  Roll the blower unit 90° so that fan blade openings 

are facing out the back of the oven. 

Blower Plate

    Replace the blower plate in the same position 

as before with the screws.

Before Rolling

After Rolling

Back of Oven

End A

End B

Back of 

Oven

Back of 

Oven

   NOTE: The blower unit exhaust openings should 

match exhaust openings on rear of microwave oven.

Blower Plate Screws

    Attach the exhaust adaptor to the rear of the oven 

by sliding it into the guides at the top center of the 

back of the oven.

    Secure the exhaust adaptor to the oven with  

the two bronze metal screws provided.

    Push in securely until it is in the lower locking tabs. 

Take care to assure the damper hinge is installed 

so that it is at the top and that the damper swings 

freely.

Slide exhaust 

adaptor into 

guides on  

oven rear.

Exhaust Adaptor

Damper  

(hinge side up)

Locking  

Tabs

Guides

Back of Oven

Exhaust 

Adaptor

Screws